石英芯片电泳分离检测尿中蛋白的研究

通过对缓冲体系、缓冲液浓度、酸度、乳酸钙浓度、乙胺浓度、电泳电压和进样时间的优化选择，用石英芯片电泳一紫外检测法分离了纯人白蛋白和人运铁蛋白；在75mmol／L硼酸盐（pH10．55）（含0．8mmol／L乳酸钙、1％（φ）乙胺）运行缓冲液中，上述两组分在3min内完全分离；纯人白蛋白和人运铁蛋白的线性范围分别为1．0～15．0g/L和1．0～10．0g／L；检出限（S／N=3）均为0．5g／L，应用于临床尿蛋白分离测定，并与Helena琼脂糖凝胶电泳仪电泳结果进行比较，获得一致结果。     

PEG-PLA嵌段共聚物的合成及~(13)C NMR对平均链段长度的测定

本文报道聚乙二醇(PEG)在辛酸亚锡存在下与丙交酯(LA)反应合成PEG-PLA嵌段共聚物,用~(13)C NMR测定了共聚物的结构,估算了平均链段长度.实验结果表明,L_(PEG)在反应过程中保持不变,而L_(PLA)随反应时间和LA在原料配比中含量的增加而增加,呈逐步聚合反应特点.对聚合反应机理作了推测.     

Use of Two-Dimensional Liquid Chromatography Combined with Diode-Array and Mass Spectrometric Detection for Analysis of Compounds in Flos Lonicera

Comprehensive two-dimensional liquid chromatographic separation by means of a combination of ion-exchange chromatography (IEC) and reversed-phase liquid chromatography (RPLC) has been realized and applied to the analysis of components of a traditional Chinese medicine Flos Lonicera. In the first dimension the components of a Flos Lonicera extract is separated on strong anion-exchange (SAX) column according to the charge-exchange properties of the components. In the second dimension the components are further fractionated by reversed-phase liquid chromatography (on ODS) on the basis of their hydrophobicity. The RPLC effluent is desalted and split and the components are identified on-line by use of both diode-array detection and mass spectrometry with atmospheric pressure chemical ionization (APCI–MS). In this way, the extract of Flos Lonicera can be rapidly separated, desalted, and analyzed, with determination of molecular weight. More than 58 components of an extract of Flos Lonicera were well resolved and six were tentatively identified from their UV and mass spectra.     

Studies on synthesis and infrared and fluorescence spectra of new europium and terbium complexes with an amide-based open-chain crown ether

An amide-based open-chain crown ether ligand and its complexes with europium and terbium were synthesized. The complexes were characterized by elemental analysis, infrared spectra and conductivity. The europium and terbium ions were found to coordinate to the C=O oxygen atoms and pyridine nitrogen atoms. The fluorescence properties of these complexes in DMF and CH3OH/CHCl3 were studied. Under the excitation of UV light, these complexes exhibit characteristic fluorescence of europium and terbium ions. The solvent factors influencing the fluorescent intensity are discussed.     

吡啶—2,6—二羧酸体系导数荧光法同时测定铀,钐,铕,铽,镝

本研究了吡啶－２，６－二羧酸（ＤＰＡ）体系导数荧光法同时测定铀，钐，铕，铽，镝的最佳条件。在ｐＨ５．５，４．８×１０＾－＾５ｍｏｌ／ＬＤＰＡ，激发波长２７２ｎｍ的条件下，可分别在５１８，６３９，６２１，５３９和６６ｎｍ处测定铀，钐，铕，铽和镝，检测限分别达到７，０．４，０．００４，０．０２６和０．２５ｎｇ／ｍＬ。应用本法测定了混合成试液中上术五种离子含量，回收率为９２．３－１０８．１％。     

碱改性γ－Al_2O_3催化剂表面碱强度分布与COS水解活性的研究

用非水滴定法和Ｈａｍｍｅｔｔ系列指示剂测定了ＣＯＳ水解碱改性γ－Ａｌ_２Ｏ_３催化剂的表面碱强度分布．发现表面碱强度分布不均匀与表面能量分布不均匀相呼应．采用零点酸碱强度（Ｈ_（０，ｍａｘ））及碱中心区域分析法，Ｂｒｏｎｓｔｅｄ催化定律，进一步证实ＣＯＳ水解反应具有明显碱催化特征，较高活性催化剂的Ｈ_（０，ｍａｘ）一般为１０左右，对ＣＯＳ水解反应起主要作用的碱性中心的碱强度（Ｈ_０）为４．８≤Ｈ_０≤９．８．对碱金属氧化物改性后的γ－Ａｌ_２Ｏ_３催化剂，Ｂｒｏｎｓｔｅｄ规律在每个碱强度分区域内是适用的．     

Topology evolution and gelation mechanism of agarose gel

Kinetics as well as the evolution of the agarose gel topology is discussed, and the agarose gelation mechanism is identified. Aqueous high melting (HM) agarose solution (0.5% w/v) is used as the model system. It is found that the gelation process can be clearly divided into three stages: induction stage, gelation stage, and pseudoequilibrium stage. The induction stage of the gelation mechanism is identified using an advanced rheological expansion system (ARES, Rheometric Scientific). When a quench rate as large as 30 deg C/min is applied, gelation seems to occur through a nucleation and growth mechanism with a well-defined induction time (time required for the formation of the critical nuclei which enable further growth). The relationship between the induction time and the driving force which is determined by the final setting temperature follows the 3D nucleation model. A schematic representation of the three stages of the gelation mechanism is given based on turbidity and rheological measurements. Aggregation of agarose chains is promoted in the polymer-rich phase and this effect is evident from the increasing mass/length ratio of the fiber bundles upon gelation. Continuously increasing pore size during gelation may be attributed to the coagulation of the local polymer-rich phase in order to achieve the global minimum of the free energy of the gelling system. The gel pore size determined using turbidity measurements has been verified by electrophoretic mobility measurements.     

C9‐Iridoids from Scrophularia buergeriana

Four new iridoids, buergerinins B–E ( 1 – 4 ), along with three known iridoids, were isolated from the roots of Scrophularia buergeriana. Their structures were identified on the basis of spectroscopic analysis.     

Study on synthesis of two-armed polymers containing a crown ether core and their self-assembly behaviors in selective solvents

A series of well-defined two-armed polymers containing a crown ether core, poly(stearyl methacrylate)-crown ether-poly(stearyl methacrylate) (PSMA-crown-PSMA), with different molecular weight were synthesized via atom transfer radical polymerization (ATRP). The resultant polymers were characterized by ¹H NMR and GPC. The self-assembly behaviors of this kind of polymer in selective solvents were studied by TEM, and it was found that polymers with different molecular weight can directly self-assemble into hollow spheres, solid spheres and a monolayer film with regular pores by varying molecular weight and water content. The possible molecular packing motels for their self-assembly behaviors were proposed.